Page 20 - Tiling Guide Uniclass Index

SPECIAL INSTALLATION CONSIDERATIONS
Tiling to Calcium Sulfate (Anhydrite) Screeds
Preparation is particularly important when it comes to calcium sulfate screeds and good practice at this early stage cannot be overstated. Tilers must be aware of a number of potential problems as below:
• The formation of ettringite, resulting from the cement and water in the tile adhesive reacting with the gypsum in the screed, which could cause tile debonding.
• As calcium sulfate cures, a weak layer of laitance is formed on the surface. This layer, which must be removed, is too weak to tile onto and also slows the drying time of the screed.
• Calcium sulfate screeds may be difficult to identify. They can look very similar to a sand:cement screed. If a screed is suspected to be calcium sulfate based, the screed should be thoroughly sealed as
a precaution.
• When underfloor heating is incorporated, heating pipes or elements should be covered by at least 25mm bed depth.
The screed must be allowed to dry out and prepared as per the screed manufacturer’s recommendations. Generally anhydrite screeds should be allowed to dry at a rate of 1 day per mm of screed thickness for screeds up to 40mm thickness, and 2 days per mm for any additional thickness over 40mm to achieve a moisture content of no greater than 1% w/w or 75% Relative Humidity (RH).
The surface should be mechanically sanded and vacuumed to remove all contamination, dust and laitance.
Seal the floor with an appropriate primer repeatedly until no more is absorbed and allow the primer to dry before tiling commences. Always consult the manufacturer for full details.
18
A - S1/S2 Tile Adhesive
B - Tiles
C - Primer
D - Calcium Sulfate Screed E - Insulation
F - Heating Pipes
G - Concrete Substrate
For further advice consult TTA’s Technical Publication ‘Tiling to Calcium Sulfate Based Screeds’.