Page 8 - Tiling Guide Uniclass Index

3 SLIP RESISTANCE OF FLOOR TILES
When planning a tiling project, it is important to ensure that you choose a tile that is suitable for its intended use, and is safe and easy to maintain.
The slip resistance property of the tile should be considered for safety reasons. For instance, areas such as a swimming pool surround or shower area require a higher degree of wet slip resistance than areas that will remain predominantly dry.
The UK Health & Safety Executive (HSE) recommends the use of the Pendulum Test. The slip potential classification based on Pendulum Test Values (PTV) are as below:
The slip resistance of a floor in service is dependent upon the surface and its environment. It is important to recognise that this can change significantly with the introduction of a lubricant e.g. water and during the process of installation and finishing. For floors where its anticipated use is likely to involve wetting or other lubricant, contamination slip resistant surface tiles should be used. Generally, dry floors are not slippery but the combination of very smooth floors and hard smooth heel or sole material can be slippery even when dry. Similarly, dry contaminants such as dust, fibres and lint can make any dry, smooth surfaced hard flooring slippery.
Once the tiles have been fixed, it is important to regularly clean the floor, rather than allow a build- up of dirt. Clients should be made aware of the importance of regular cleaning and maintenance for safety reasons.
For further advice consult TTA’s Technical Publication ‘The Slip Resistance of Hard Flooring’.
TTA offers a Pendulum Slip Resistance Testing Service. Testing is available to members at a discounted rate. Although TTA is not a UKAS accredited test house, the service will provide an independent and indicative test. Call 0300 365 8453 or email technical@tile.org.uk to book.
PTV
0-24
High slip potential
25-35
Moderate slip potential
>36
Low slip potential
06